JOB RESPONSIBILITIES:
Perform UT (Both Longitudinal and Shear wave) Inspections and reporting independently;
Have good command on UT weld scanning by preparing scan plans, doing calibration, data analysis and report generation independently.
Conversant with use of UT electronics such as Sonatest D10, USM 35, USM GO and Panametrics etc. and accessories used in inspection;
Analyse applications, decide probes, test samples etc required for inspections;
Independently can perform MPI, DPT (both visible and fluorescent) as per ASME
Maintenance of testing equipment.
QUALIFICATION & EXPERIENCE:
Bachelors degree / Diploma or relevant Engineering qualification;
Qualified /Certified and experienced in UT Technique, holding PCN 3.1 or 3.2 in UT. Combined UT experience (longitudinal and shear wave inspection) should be at least 3 years, out of which UT weld examination experience should be 1 1/2 years;
Base NDT qualifications should be ASNT level II, MT and DP Testing;
Shall be capable of reading / reviewing general arrangement drawings, piping & instrumentation drawings (P & ID) and isometrics;
Knowledge of Inspection techniques in Oil & Gas Industrial sector;
Conversant with material, test and inspection standards;
Good communication in English, both written & spoken;
Computer skills, knowledge of MS office applications, Internet etc;
Any Nationality
2+ years experience
Hamid Raza
hamid.raza@sgs.com
http://www.sgs.com
No comments:
Post a Comment
Please give your feedback or Job Request here